| Center Section | Dana® 80-series nodular Iron low-pinion center section |
| Gear Set | Standard Dana 80 low-pinion |
| Pinion Yoke | 1350 u-joint |
| Differential Cover | High strength nodular-iron cover with fill and drain plugs |
| Axle Tubes | 4-inch diameter, .375 wall DOM tubing |
| Axles | Currie Performance full-floating 40-spline (1.7 in. diameter) 4340 heat treated chromoly |
| Floater Spindle | Currie Performance 2.5-inch 4140 Chromoly spindles |
| Floater Hub | Currie Performance hubs with 40-spline drive flanges, tone rings installed for ABS and ESP retention |
| Brake Calipers | Not included, reuses the stock Gladiator rear calipers |
| Brake Rotors | 13.75-inch vented rotors |
| Suspension Brackets | Heavy gauge 3/16-inch steel mounting brackets |
| Geometry | Optimized for lifted vehicles with 5 degrees of pinion angle to reduce driveshaft angle |
| Width | 70 or 72.5-inch wide (between wheel mounting surfaces) |
| Wheel Bolt Pattern | 8-lug (8 on 6 ½) with 9/16 studs installed |
| Finish | Satin black (fully bracketed) / Raw (W/O brackets) |